Now the starting behaviour is just the same as when my FS80 was when new. Pump a few times, full choke, cough on the first pull, half choke, pull and it’s running, give a few seconds to warm up, no choke and it’s good to go. Might need a tweak for full power under heavy load, but so what? Great carb. The only improvement I can think of is to include some straight fuel line. The bifurcated fuel line does not work with the tank. I had to snip off the tips of the old fuel line so it would get enough grip on the new carb’s fittings
It took me about 10 minutes to remove the old carburetor and replace it with this new one on my Stihl trimmer. The trimmer is about seven years old. Runs and idles like it is brand new again without any adjustments to the new carburetor.
Very good glue ….. it can be used on most anything …. Bonds well with no visible traces of glue ….. little goes a long wayyy …. I like it because I can control the spread
Had typical Stihl run and stall problem. Installed new parts in 45min, primed 8 times,pulled starter cord. Runs like new, didn't even have to adjust hi, low screws. Great deal!!
I’m usually afraid to buy after market carburetors, but I’ve bought 2 of these and they both bolted on and ran perfect. This will be my 3rd one. I hope it works as good as the first 2.